P2000A GaN Probe

Model	Description	Price
P2000A	GaN Probe, Accessory Kit (Regularly priced at $650.00)	DISCONTINUED
P2001A	GaN Probe 2-Pack, Accessory Kit	DISCONTINUED

The Picotest GaN Probe extends the measuring range of your oscilloscope to high voltages safely and easily. Applications include power supplies and LiDAR.

This high voltage probe is suitable to view the fastest GaN (Gallium Nitride), eGaN, and SiC (Silicon Carbide) edges for timing and switching losses of high voltage power switches, as well as, EMC testing or glitch detection.

Anyone designing with high speed, high voltage switches can use this probe. Circuit designers and those testing electrical cars components will especially love this probe.

For test setups that need a 50 ohm connection, you can use the J2180A Ultra Low Noise Preamp which converts from the 1MOhm probe impedance to a 50 ohm impedance.

GaN Probe
Target Specifications
Characteristic		Rating
System Bandwidth		700 MHz (-3 dB)
Attenuation Ratio (1)		100:1 ± 2 % at DC Connected to oscilloscope with an input impedance of 1 MO ± 1 %.
Absolute Maximum Voltage		< 1000V rms
Voltage Coefficient		0.00025 %/V %/V (typical)
Probe Rise Time		500 psec (10 % - 90 %) (typical)
Maximum Rated Input Voltage (2)		As defined in IEC 61010-031. Also see definitions in User Manual.
Measurement category I:		1000 V rms 4000 V transient overvoltage
Measurement category II:		1000 V rms CAT II
Input Resistance (System)		50 MO ± 1 %
Input Capacitance (System)		7 pF (typical)
Compensation Range		10 pF - 50 pF (typical)
Input Coupling of the Measuring Instrument		1 MO AC / DC
Weight (probe)		82g
Cable Length		1m
Probe Tip Diameter		5mm
Temperature Range		operating 0° C to +50° C non-operating -40° C to +71° C
Maximum Relative Humidity		operating 80% relative humidity for temperatures up to +31° C, decreasing linearly to 40% at +50° C
Usage		Indoor
Altitude		Operating up to 2000m (6,561 feet), non-operating up to 15000m (49,212 feet)
Absolute Maximum Voltage		See ratings above

The specifications are subject to change without notice.

The probe is compatible with all 1MOhm equipment including Oscilloscopes and Spectrum Analyzers.

For those that need a 50 ohm connection, you can use the J2180A Ultra Low Noise Preamp which converts from the 1MOhm probe impedance to 50 ohms.

Caution: To avoid equipment damage and/or severe injuries or death ensure that the absolute maximum ratings are observed and not exceeded at all times.