Model	Description	Price
J2121A	J2121A High Power Line Injector	$2,495.00	Add to Cart

While the injection transformer used for Bode plots is a very wideband transformer, it is not useful for measuring ripple rejection (PSRR) of a power supply or even an opamp. Doing so could permanently damage the transformer. This is because the attributes that make the injection transformer perform so well also result in a transformer that is intolerant of DC current. Even very small DC currents (5mA or less) can greatly reduce the signal capacity or even totally saturate the transformer. For this reason, the Picotest line injector (J2121A) is another essential test adapter for power supply testing.

The J2121A is especially suited to high power applications such as those associated with military and satellite busses. It can be used with input bus voltages up to 400V and supply up to 20A at 1MHz. The line injector allows the input DC supply voltage to be modulated by the network analyzer source signal (oscillator). The J2121A line injector output is DC regulated and provides a fixed voltage drop of 750mV from the input bus voltage fed into the injector in addition to the AC modulation signal.

The J2121A can be connected to the power supply input under test and, depending on the test probe connection points, can be used to measure either PSRR or the power supply’s input impedance The line injector can also be used to measure the impedance/inductance of an inductor under bias.

While a current probe can be used as part of a test setup, the J2121A includes a current sense monitor output that can be connected to the VNA.

The J2121A comes with the J2171A power supply and connecting cable, used to power it, and a 1-ohm calibration fixture.

Specifications
Characteristic		Typical	Units
Maximum DC Input Voltage		400	VDC
Maximum Continuous Current		20	A
Typical Input-Output Voltage Drop		0.75	VDC
Transfer Gain		unity gain, whatever the modulation amplitude is set to (up to ~500mVpk) is what the modulation amplitude will be at the J2121A output	-
Modulation Input Impedance		50	ohms
Output Signal Bandwidth		100-1M	Hz
Current Monitor Bandwidth (THRU CAL)		DC-1M	Hz
Current Monitor Scale (AC)		100	mV/A
Current Monitor Termination Impedance		> 10	KOhms
Max Current Monitor DC Offset		100	mV
Recommended Injection Signal		6	dBm
Temperature Range		0-50	C
Maximum Altitude		6000	Ft

Inputs

• Bus Voltage: Plus and minus, standard banana jacks female
• Signal Modulation: BNC
• Power: J2171A proprietary connector, cable and power supply included

Outputs

• Voltage Output: Plus and minus, standard banana jacks female
• Isolated Current Sense Monitor: BNC

Caution: To avoid equipment damage and/or severe injuries or death ensure that the absolute maximum ratings are observed and not exceeded at all times.

Application notes

DC-DC Converter Input Impedance Measurement

Solution Brochures

• DC-DC Converter Input Impedance Testing
• DC Biased Inductor Measurements


• DC Biased Inductor Measurements with Tektronix 5/6 Series MSO
• DC-DC Converter Input Impedance Testing with the Tektronix 5/6 Series MSO

Videos

Accurately Measure Inductance with DC Bias to 125 Amps